AEG Pure Multi 7000 Manual De Operación página 7

UNBOXING & SETUP
Please be careful while unboxing the air purifier. The unit has several detachable components
which may have come loose in transport, so open the box with care and while placed on a large
flat surface on the floor.
1. Remove the front panel by gently pulling it away from the unit with both hands.
2. Take out the mesh pre-filter, ultrafine particle filter and VOC odor filter and remove all plastic
packaging. Discard as per safety and local recycling instructions.
3. Place the filters back into the unit in the same order as originally found (i.e. VOC odor filter goes
in first).
4. Attach the mesh pre-filter and the front panel back to the unit. (refer to image 1&2).
5. Plug the unit's power cord to the nearest power socket so that the ON/OFF button on the
product control panel gets illuminated.
6. For best results, operate the unit in an enclosed area with doors & windows closed when
feasible.
CONTROL PANEL STATES
7. STANDBY STATE: Once plugged, the unit is on standby state, the indicators on the control panel
are dimmed except POWER button (30%) and Wifi icon (will only blink if activating onboarding).
8. DAY & NIGHT: The unit is equipped with a light sensor, which measures the light conditions in
the room. The sensor will dim the light intensity of the display and limit the fan speed to fan
speed 2 when using the product in a dark room to give a non-disturb user experience during
night time.
9. INACTIVE STATE: If user does not interact with the control panel for over 15 seconds, the control
panel will enter inactive state where the active buttons and indicators are dimmed to 30%, and
the rest of the display panel will be fully dimmed.
USING YOUR PRODUCT
TURNING ON
10. Press the ON/OFF button
mode and the louvres pointing forward) when used the unit the first time. Next time you start
the unit it will resume the last settings you had before turning OFF the product.
NOTE: When turning ON the air purifier, it will take about 10 seconds for the sensors to calibrate
and analyze the air quality. During this time, the air quality indicator will pulsate slowly in white.
CHANGING MODES & FAN SPEEDS & SWING & HUMIDITY
11. Press the MODE button
SMART: This is the default mode the unit will start in. In the SMART mode the unit will utilize
the sensor data as input to decide on the appropriate fan speed and humidification level for
a comfortable air environment ,depending on the temperature in the room. The fan speed
or humidification level, can not be adjusted by the user under this mode. Please see the AIR
QUALITY INDICATOR section for more details.
MANUAL: In the MANUAL mode the unit will utilize the sensor data as input only to show the
air quality level via the air quality indicator but will not self-adjust the fan speed. This mode is
best utilized for a quick burst of cleaning, especially when the user anticipates an increase in
particulate matter in the room due to household chores (e.g. vacuuming).
12. FAN SPEED: While in MANUAL mode, Press the FAN button to adjust the fan speed – the air
purifier has 5 levels fan speed, the fan speed indicator will show the fan speed.
NOTE: The unit will ramp up OR down to chosen speed setting gradually.
www.aeg.com
to turn ON the air purifier, the unit will run in default setting (SMART
once to toggle between the two modes: SMART and MANUAL
7