Before Start-Up - Clarke FOCUSII Instrucciones De Uso

BEFORE START-UP

Brush/pad-holder deck or cylindrical brush deck
installation/removal
On the machine it is possible to install/remove either the brush/
pad-holder deck (A, Fig. 9) or the cylindrical brush deck (E).
For deck installation/removal see the procedure in Maintenance
chapter.
Brush/pad-holder installation/removal
1. According to the kind of cleaning to be performed, the
machine can be equipped either with brushes (B) or pad-
holders (C) with pads (D) together with the appropriate deck.
2. Insert the ignition key (A, Fig. 10) and turn it to "I".
3. If equipped, turn the speed adjuster (B) to idle by turning it
counter-clockwise.
4. Place the brushes (B, Fig. 9) or the pad-holder (C) under the
17 in / 20 in (430 mm / 530 mm) deck (A).
5. Lower the deck on the brushes/pad-holders by pressing the
pedal (C, Fig. 10).
6. Turn the ignition key (A) to "I".
7. Press the brush/pad-holder switch (D).
8. Press one of the switches (E) to engage the brush/pad-
holder, then release it. If necessary, repeat the procedure
until the brushes/pad-holders are engaged.
WARNING!
(Only for FOCUS II L17, FOCUS II L20): Turn the
speed adjuster (B, Fig. 10) counter-clockwise to drive
the machine at the minimum speed.
To engage the brush/pad-holder press the switch (E)
which turns on the brush/pad-holder motor.
9. To remove the brushes/pad-holders, the deck must be lifted
by pressing the pedal (C), then press the switch (F) and wait
for the brush/pad-holder to fall on the floor.
Turn the ignition key (A) to "0".
Operator's Manual - FOCUS II L17 - S20 - L20 - L20 Cyl. - BOOST
®
Figure 9
Figure 10
L20
®
ENGLISH
13