After Using The Machine; Machine Long Inactivity; First Period Of Use - Clarke FOCUSII Instrucciones De Uso

ENGLISH
Solution/clean water tank emptying
6. Perform steps 1 to 4.
7. Empty the solution tank with the hose (A, Fig. 23). After
working, rinse the tank with clean water.
Cylindrical brush debris container emptying (only for
cylindrical brush deck)
8. Stop the machine.
9. Lower the cylindrical brush-holder deck and remove the
debris container (A, Fig. 24) by pulling it on one side with the
handle (B).
10. Empty and wash the debris container (A), and then install it
by engaging it on the fasteners.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders as shown on pages 13 and
15.
2. Empty the tanks (B and C, Fig. 23) and the debris container
(A, Fig. 24) as shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the
Maintenance chapter).
4. Store the machine in a clean and dry place, with the brushes/
pad-holders and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in After Using the machine
paragraph.
2. Disconnect the battery connector (D, Fig. 23).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and
connecting parts for proper tightening and check the visible parts
for wear and leakage.
22
Operator's Manual - FOCUS
Figure 23
Figure 24
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
®