Clarke FOCUSII Instrucciones De Uso página 31

Battery charging with battery charger installed on the
machine
7. Connect the battery charger cable (A, Fig. 40) to the
electrical mains (the electrical mains voltage and frequency
must be compatible with the battery charger values shown
on the machine serial number plate (D, Fig. 39).
When the battery charger is connected to the electrical
mains, all machine functions are automatically cut off.
If the red warning light (B, Fig. 40) on the battery charger
control panel stays on, the battery charger is charging the
batteries.
8. When the green warning light (C) turns on, the battery
charging is completed.
9. When the battery charging is completed, disconnect the
battery charger cable (A) from the electrical mains and wind
it round its housing (D).
10. Carefully lower the tank (D).
NOTE
For further information about the operation of the battery
charger (E, Fig. 40), see the relevant Manual.
Operator's Manual - FOCUS II L17 - S20 - L20 - L20 Cyl. - BOOST
®
Figure 39
Figure 40
L20
®
ENGLISH
31