Machine Transport Procedures; Symbols Shown On The Machine - Clarke FOCUSII Instrucciones De Uso

MACHINE TRANSPORT PROCEDURES

How to load and unload the machine from a van or a
truck
WARNING!
This machine is heavy. Machine transport must be
performed by qualified personnel only. Machine
transport on steep ramps must be performed by two
well-trained operators only. Always move it slowly.
Do not turn the machine on slopes. Do not leave the
machine unattended on slopes. Loading ramp width
must not be less than 40 in (1 m).
1. Check that the loading ramp is not longer than 8 feet (2.5
m) and not wider than 40 in (1 m). Its thickness must be
adequate to support the machine and operators' weight.
2. Check that the ramp is dry and clean.
3. Position the ramp properly.
4. Before loading the machine, remove the squeegee assembly
and the brush/pad-holder. Before loading the machine,
empty both the solution and the recovery water tank.
How to Fasten the Machine Inside the Vehicle
5. Clarke recommends to fasten the machine with belts during
transportation.

SYMBOLS SHOWN ON THE MACHINE

Operator's Manual - FOCUS
WARNING!
Carefully read all instructions before performing any procedure.
WARNING!
Do not wash the machine with direct or pressurized water jets.
WARNING!
Do not use the machine on slopes exceeding the specifications.
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
Figure 1
L20
®
ENGLISH
7