Bulb Replacement - BFT EOS Instrucciones De Uso

ENGLISH
Thank you for buying this product, our company is sure that you will be more
than satisfied with the product's performance. The product is supplied with
a "Warnings" leaflet and an "Instruction booklet". These should both be
read carefully as they provide important information about safety, installation,
operation and maintenance. This product complies with the recognised
technical standards and safety regulations. We declare that this product is
in conformity with the following European Directives: 89/336/EEC and 73/
23/EEC, 98/37/EEC (and subsequent amendments).
1) GENERAL OUTLINE
The EOS system is compatible with the EElink protocol for fast installation
and maintenance. It is suitable for motorising sectional doors, protruding
fully retracting spring operated overhead doors and counterweight overhead
doors provided with an appropriate towing arm. The overhead door must
not be higher than 2.5 metres. It is easy to install and fast to fit and does not
need the door to be modified. The irreversible gearmotor keeps the door
locked in the closing position. The control unit is builtin. It controls the
operation relays and the safety devices (photocell, rubber skirt) before
performing every manoeuvre.
This product was designed to motorise the types of door mentioned
above. Any other use is considered contrary to that intended by the
manufacturer who, therefore, cannot be held responsible for any
injuries to persons or animals, or damage to things which might
derive from misuse.
2) SAFETY
If correctly installed and used, this automation device satisfies the required
safety level standards. However, it is advisable to observe some practical
rules in order to avoid accidental problems. Before using the automation
device, carefully read the operation instructions and keep them for future
reference.
4 -
EOS - Ver. 07
USER'S MANUAL
• Keep children, persons and things outside the automation working area,
particularly during operation.
• Keep radio control or other control devices out of children's reach, in
order to avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• Do not attempt to open the door manually, if the internal locking system
has not been released by pulling the appropriate wire connected to the
carriage, or the external lock (SM1 or SET/S) activated.
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the
emergency release to gain access to the automation device and request
the assistance of a qualified technician (installer).
• Before proceeding to any external cleaning operation, disconnect the
mains powers supply.
• Keep the photocell optical components and luminous signal indication
devices clean. Check that the safety devices (photocells) are not
obscured by branches or shrubs.
• For any direct assistance to the automation system, request the
assistance of a qualified technician (installer).
• Have qualified personnel check the automation system once a year.
3) EMERGENCY MANOEUVRE
In case of electric power failure or system malfunction, the manoeuvre must
be carried out manually by pulling the wire connected to the carriage, as in
fig.1. For garages which are not provided with a second exit, it is compulsory
to fit an external key release device like Mod. SM1 (fig.2) or Mod. SET/S
(fig.3).

4) BULB REPLACEMENT

To replace the courtesy light bulb, remove its transparent cover (Fig.4).
WARNING: Only 24V 25W max E14 bulbs must be used.