Publicidad
Idiomas disponibles
Idiomas disponibles
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
Belt Replacement
Auger Belt
To remove and replace your snow blower's auger belt, proceed as follows:
1.
To prevent spillage, remove all fuel from tank by running engine until it
stops.
2.
Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 54.
SERVICE AND MAINTENANCE
3.
4.
5.
31
Figure 54
Roll the auger belt off the engine pulley. See Figure 55.
Figure 55
Carefully pivot the snow blower up and forward so that it rests on the auger
housing.
Remove the frame cover from the underside of the snow blower by removing
four self-tapping screws which secure it. See Figure 56.
Figure 56
Publicidad
