Publicidad
Idiomas disponibles
Idiomas disponibles
5. Confirm by pressing the
selection occurs after 10 seconds.
The timer begins counting down immediately.
A buzzer sounds for approximately 1 minute and the
cooking zone switches off when the set programme
has finished.
Repeat the above procedure for each hotplate you
wish to programme.
Using multiple programmes and the display
If one or more hotplates are programmed, the display
will show the data for the hotplate with the least time
remaining, and the light corresponding to the position
of the hotplate will flash. The lights corresponding to
the other hotplates programmed will be switched on.
To visualise the time remaining for the other
programmed hotplates, press the
repeatedly: the time remaining for each hotplate will be
shown sequentially in a clockwise order, starting from
the front left hotplate.
Changing the programme
1. Press the
button repeatedly until
the duration you wish to change is shown.
2. Use the
buttons to set the new duration.
3. Confirm by pressing the
To cancel a programme, follow the above instructions.
-
At step 2, press the
button: the duration decreases
progressively until it reaches 0 and switches off. The
programme resets and the display exits programming
mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99
minutes.
1. Press the
programming button until the timer
indicator light is illuminated
2. Set the desired duration using the
buttons.
3. Confirm by pressing the
The timer begins counting down immediately. When
the time has elapsed, a buzzer will sound (for one
minute).
button or automatic
button
button.
.
-
+
and
button.
Control panel lock
When the hob is switched on, it is possible to lock the
oven controls in order to avoid accidental changes
being made to the settings (by children, during
cleaning, etc.). Press the
panel: the indicator light above the button will switch
on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the
few moments, the indicator light will switch off and the
lock function will be removed.
Switching off the hob
Press the button
to switch off the appliance - do not
rely solely on the pan sensor.
If the control panel lock has been activated, the
controls will continue to be locked even after the hob is
switched on again. In order to switch the hob on again,
you must first remove the lock function.
"Demo" mode
It is possible to set the hob to a demonstration mode
where all the controls work normally but the heating
elements do not switch on. To activate the "demo"
mode the hob must be switched on, with all the
hotplates switched off.
+
• Press and hold the
and
simultaneously for 6 seconds. When the 6 seconds
have elapsed, the ON/OFF and CONTROLS
LOCKED indicator lights will flash for one second.
+
-
Release the
and
buttons and press the
button;
• The display will show the text DE and MO and the
hob will be switched off.
• When the hob is switched on again it will be set to
the "demo" mode.
To exit this mode, follow the procedure described
above. The display will show the text DE and OF and
the hob will be switched off. When it is next switched
on, the hob will function normally.
Practical advice on using the appliance
! Use cookware made from materials which are
compatible with the induction principle (ferromagnetic
material). We especially recommend pans made
from: cast iron, coated steel or special stainless
button to lock the control
button for a
-
buttons
15
GB
Publicidad
