Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 6. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white wires and safety cable through the
downrod. (Figure 3)
4.
Insert downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two
set screws with nuts in the downrod support.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Hanger
Ball
Hairpin Clip
Set Screws
and Nuts (2)
Downrod
Hairpin Clip
7
Pin
Set Screw
Figure 1
Downrod
Clevis Pin
Figure 2
Black, White Wires
and Safety Cable
Downrod
Figure 3
Clevis Pin
Set Screws (2)
Figure 4
Publicidad
