Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan (Continued)
5. Route wires and safety cable through motor
coupling cover, canopy screw cover and ceiling
canopy. (Figure 5)
6.
Reinstall the hanger ball on the downrod as follows.
Route the black, white wires and safety cable through
the hanger ball. Position the pin through the two holes
in the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
7.
Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
8.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Ceiling Canopy
Motor Coupling
Cover
Hanger Bracket
8
Canopy Screw
Cover
Figure 5
Figure 6
Figure 7
Figure 8
Publicidad
