Cramer 82PC300 Manual Del Operario página 4

EN
1 DESCRIPTION
1.1 PURPOSE
This product is used for cutting concrete and metal. It is not
designed for cutting wood.
This appliance is not intended for use by persons with
reduced understanding, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for
their safety.
Never allow children to operate this product.
Never allow adults to operate this equipment without proper
instruction.
1.2 OVERVIEW
Figure 1-12.
Guard
1
Front handle /
2
Auxiliary handle
Lock-out button
3
Trigger
4
Rear handle / Main
5
handle
Abrasive cutting
6
wheel
13 mm wrench
7
Coupling
8
Water adjuster
9
10 Guard adjustment
lever
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
Do not change or use accessories that are not recommended
by the manufacturer.
11 Spindle lock button
12 Screw
13 Outer thrust washer
14 On/off button
15 Battery release button
16 Light button
17 LED light
18 Magnet filter
19 Shaft sleeve
20 Warning light
WARNING
WARNING
English
Do not install battery pack until you assemble all the parts.
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 INSTALL THE WHEEL
Figure 2-3.
Wear adequate clothing, gloves and goggles before touching
the wheel.
The composite abrasive wheel is suitable for steel materials;
the diamond abrasive wheel is suitable for concrete
materials.
Note the arrows on the guard indicating the direction of
rotation. Make sure the wheel is fitted in the same direction.
1. Press and hold the spindle lock button.
2. Remove the washer and screw.
3. Fit the wheel, washer and screw.
4. Tightining the screw with 25 Nm Torque.
3.3 ADJUST THE ANGLE OF GUARD
Figure 4.
The guard can be adjusted to different angles.
1. Pull the guard adjustment lever rearward and hold it.
2. Move the gurad to the desired angle.
4
WARNING
WARNING
WARNING
CAUTION
CAUTION
WARNING