Cramer 82PC300 Manual Del Operario página 5

3. Release the guard adjustment lever.
3.4 INSTALL THE BATTERY PACK
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
4.1 SPECIFIC SAFETY WARNINGS
Figure 6-7.
• Danger of kickback – Kickback can result in fatal
injuries. Kickback occurs when the cut-off machine is
suddenly thrown up and back in an uncontrolled arc
towards the operator.
• Do not stand in line with the abrasive wheel. Ensure
sufficient freedom of movement, especially in
construction trenches there must be sufficient space for
the user and for the part being cut to fall. Do not lean too
far forwards and never bend over the abrasive wheel.
• Frequently inspect the cutting wheel – replace it right
away if there are visible cracks, buckling or other damage
(for example, overheating) – risk of accident due to
breakage!
English
You must follow the instruction attached or marked on each
specific cutting equipment.
Wet cutting blade must always use water cooling system!
4.2 HOLD THE MACHINE
Figure 8.
1. Hold the machine with one hand at the rear handle and
with the other hand at the front handle. Always use both
hands when using the machine.
2. Hold the handles with the thumbs and the fingers around
them.
3. Make sure that the thumb of the hand that holds the front
handle is below the handle.
4.3 START THE MACHINE
Figure 9.
1. Press the on/off button.
2. Press the lock-out button.
3. Press the trigger while you hold the lock-out button.
4.4 STOP THE MACHINE
Figure 9.
1. Release the trigger to stop the machine.
2. Press the on/off button.
4.5 LED LIGHT
Figure 9-10.
The LED light illuminates when the switch is depressed.
It provides extra light for increased visibility.
1. Press the light button to turn on the LED light.
2. It can light up the work area and provide a cutting line.
3. Press the light button again to turn off the LED light.
4.6 FUNCTION OF CONTROL PANEL
ON/OFF button
• 1 push – power on/off.
• 1 minute delay of inactivity – power turns off .
• If light is on. 1 minute delay of inactivity – stand by.
Light button
• When power is on 1 push – light on/off .
• 10 minutes delay of inactivity – light turns off .
• Last minute of delay flashes will occur before light turns
off .
5
IMPORTANT
EN