Cramer 82PC300 Manual Del Operario página 6

EN
4.7 CONNECT THE WATER SUPPLY
Figure 11.
Wet cutting is used only with the diamond abrasive wheel
when cuting concrete.
Follow the instruction on the cutting equipment before
applying water.
In sub-zero temperature, the water must be drained out from
the pipe after finishing work to avoid the risk of freezing.
1. Assemble the water supply to the connector.
2. Connect coupling to the machine.
3. Adjust the water flow by the adjuster. After work, stop
the machine and close the water supply.
Do not cut after closing the water supply. The concrete
grout can block the water outlet.
4. Disconnect the water supply from the connector.
5 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1 REPLACE THE WHEEL
Figure 2-3.
Use only approved replacement blades.
Wear adequate clothing, gloves and goggles before touching
the wheel.
1. Stop the machine.
2. Press and hold the spindle lock button.
WARNING
WARNING
CAUTION
NOTE
CAUTION
CAUTION
WARNING
WARNING
CAUTION
English
3. Remove the wheel, washer and screw.
The machine applies to two sizes (20 mm/25.4 mm) of
wheel bore. You can change to the other size via turning
over the shaft sleeve.
4. Fit the new wheel, washer and screw.
5. Tightining the screw with 25 Nm Torque.
5.2 CLEAN THE MACHINE
Figure 12.
• Remove the battery pack from the machine before
cleaning.
• Check and clean the magnet filter after every working
shift cutting in metal.
• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do never clean the battery or the machine with water
hose. Do never clean the battery or the machine with
pressure washer.
5.3 TRANSPORTATION AND
STORAGE
Before you move the machine, always
• Remove the battery pack from the machine.
• Keep hands clear of the switch.
Before you put the machine into storage, always
• Remove the battery pack from the machine.
• Make sure to clean the machine before storage.
• Make sure that the storage area is
• Not available to children.
• Away from agents which can cause corrosion, such as
garden chemicals and de-icing salts.
6
NOTE