Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. J
30
Fig. K
Speed Adjustment (Fig. A2)
The speed can be regulated between 2500 and 4200 rpm
using the speed wheel
19
. This enables you to optimize
the cutting speed to suit the material. Refer to the following
chart for type of material and speed range.
Type of Material to be Cut
Solid wood (hard, soft)
Chipboards
Laminated wood, blockboards, veneered and coated boards
Paper and carton
Door Cutting (Fig. L)
1. Place the track saw with the outer guard
flat floor.
2. Press the shoe
4
with the front side on the door against
the adjusted depth stop.
30
28
30
45˚
28
30
0˚
28
Speed Range
3–7
4–7
2–7
1–3
23
on a clean,
Fig. L
4
Dust Extraction (Fig. A2)
Your tool is fitted with a dust port
WARNING: DO NOT direct sawdust toward yourself
or others. DO NOT insert foreign objects into the
exhaust opening.
WARNING: ALWAYS connect the track saw to a dust
extractor!
WARNING: ALWAYS use a dust extraction device
designed in accordance with the relevant regulations
regarding dust emission.
WARNING: Static charge may occur if an anti-static
suction hose is not used.
A universal 1-1/4" dust extraction hose can be connected to
the dust port
17
. Check for a tight connection before use.
Dust Duct Cleaning
Depending on your cutting environment, saw dust can clog
the dust duct and may prevent dust from flowing away
from the cutting area properly. With the battery removed,
low pressure air or a large diameter dowel rod can be used
to clear the dust out of the dust duct.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
English
23
.
17
13
Publicidad
