Descargar Imprimir esta página

SICK PowerProx WTT12L Instrucciones De Uso página 22

Fotocélulas multitarea
Ocultar thumbs Ver también para PowerProx WTT12L:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
OPERATING INSTRUCTIONS
3
Product description
3.1
Product identification via the SICK product ID
en
3.2
Additional functions
4
Mounting
22
O P E R A T I N G I N S T R U C T I O N S | PowerProx - WTT12L
Qualified personnel are able to perform tasks assigned to them and can independently
recognize and avoid any potential hazards. This requires, for example:
technical training
experience
knowledge of the applicable regulations and standards
SICK product ID
The SICK product ID uniquely identifies the product. It also serves as the address of the
web page with information on the product.
The SICK product ID comprises the host name pid.sick.com, the part number (P/N),
and the serial number (S/N), each separated by a forward slash.
The SICK product ID is displayed as text and QR code on the type label and/or on the
packaging.
Figure 2: SICK product ID
Test input: The WTT12L sensor features a test input ("TI" or "Test" on the connection
diagram), which can be used to switch the sender off and therefore check that the
sensor is functioning correctly: If female cable connectors with LED indicators are used,
you must ensure that the TI is assigned accordingly.
There must be an object in the path of the beam (light reception); activate the test
input (see the connection diagram , TI 24 V). Sender LED is switched off. No object
being detected is simulated. Refer to
output fails to behave as described in
"Troubleshooting", page 27
The sensor can be used in standard I/O mode (SIO) or IO-Link mode (IOL). All auto‐
mation functions and other parameter settings are effective in IO-Link mode and in
standard I/O mode (exception: Time stamp). Output of binary switching signals during
standard I/O operation via pin 4 / black wire or via pin 5 / gray wire.
Information on the IO-Link functions can be found in the enclosed IO-Link photoelectric
sensors operating instructions or downloaded from www.sick.com under the device part
number.
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Note the sensor's maximum permissible tightening torque of 0.8 Nm.
Observe preferred direction of the object to the sensor
figure 7
to check the function. If the digital
figure
7, check the application conditions.
[figure
3].
see
8018110.1K5W/2023/07/10 | SICK
Subject to change without notice

Publicidad

loading