Scan; Temporary Channel Lockout; Scan Delete/Add - Kenwood TK-5220 Manual De Instrucciones

Scan monitors for signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel
and only stops if a signal is present.
To begin scanning, press the key programmed as Scan.
• The icon appears on the display.
• When a signal is detected on a channel, Scan pauses at that
channel. The transceiver will remain on the busy channel until the
signal is no longer present, at which time Scan resumes.
To stop scanning, press the Scan key again.
Note: To use Scan, there must be at least 2 channels in the scan
sequence.

TEMPORARY CHANNEL LOCKOUT

During scan, you can temporarily remove specifi c channels
from the scanning sequence by selecting them and pressing
the key programmed as Scan Delete/Add.
• The channel is no longer scanned. However, when scanning is
ended and restarted, the channels are reset and deleted channels
will again be in the scanning sequence.

SCAN DELETE/ADD

You can add and remove zones and/or channels to and from

scan.

1 Select your desired zone and/or channel.
2 Press the key programmed as Zone Delete/Add (to add/
remove zones) or Scan Delete/Add (to add/remove
channels).
• You can also press and hold the key programmed as Scan
Delete/Add to add/remove zones.
SCAN
15