WEG MW500 G2 Manual De Usuario página 40

Powering up and Start-up
Step Indication on the Display/Action
13
If necessary, modify the content of "P0407 - Motor
„
Rated Power Factor", or press the key
next parameter
15
D u r i n g th e S e l f-Ad j u s tm e n t th e H M I R w i l l
„
simultaneously indicate the status of "RUN" and
"CONF". And the bar graph indicates the progress
of the operation
And the bar graph indicates the progress of the
„
operation. The Self-Adjustment can be interrupted
at any time by means of the key
17
The result of Self-Adjustment is the value in ohms of
„
the motor stator resistance shown in P0409
This is the last parameter of the Self-Adjustment of
„
the V V W control mode. Press the key
to initial parameter P0202
19
Through the keys
„
menu or press the key BACK/ESC again to return
directly to the monitoring mode of the HMIR
34 | MW500
for the
to return
and , select the desired
Figure 5.5: Sequence of the Start-up group for VVW control
Step Indication on the Display/Action
14
At this point, the HMIR shows the option to do
„
the self-adjustment. Whenever possible, perform
the self-adjustment. Thus, to activate the self-
adjustment, change the value of P0408 to "1"
16
At the end of the Self-Adjustment, the value of
„
P0408 automatically returns to "0", as well as the
Status of "RUN" and "CONF" are cleared
Press the key for the next parameter
„
18
To exit the STARTUP menu, just press BACK/ESC
„