Honeywell CO25MM Manual Del Usuario página 15

DRAINING AND CLEANING THE WATER TANK
• Turn the power off and disconnect the unit from power supply.
•
Move the unit to a location where it can be drained and remove the
drainage tube/cap.
•
Once the tank is empty, refill with clean water and drain it again.
This should be repeated weekly to maintain the integrity of the unit
and to remove particles filtered from the air.
• Once the tank is clean, refill the water tank. The unit is now ready to
be used again.
CLEANING THE HONEYCOMB COOLING MEDIA
•
Turn off the unit, and unplug the power cord from wall
outlet.
•
Rotate the unit facing the back panel, and locate the
Rear Grill Removal Screws.
• Remove both the screws with a screw driver (refer fig. 1).
Pull the rear grill panel upwards, untill it is completely
removed.
•
Now, the honeycomb media can be seen. Clean both the
pads with clean cloth to remove all the dust & dirt
particles.
•
Repeat the same procedure in order to remove the
honeycomb pad from the side panel (refer to fig.2).
•
Once, the cleaning has been performed, assemble the
unit back in the same fashion as described above.
CLEANING & MAINTENANCE
Fig.1
Honeycomb
Back Panel
Fig.2
Honeycomb
Back Panel
Water Drain Plug
Honeycomb
Holder
Screw
Back Panel
Honeycomb
Holder
Screw
Side Panel
13