ETA Systems 350VA Manual Del Usuario página 14

ETA SYSTEMS - UNINTERRUPTIBLE POWER MANAGER
4. The UPM is now running on battery. When you have finished, press the On/Off switch again and return
the Start Manager switch to the "Disabled" position. Plug the input AC power cable into the rear panel
of the UPM.
7.0 – UNPACKING, INSPECTION, TESTING AND TROUBLESHOOTING
Please Note: Before installation, please read and understand the following instructions. Carefully examine
the packing carton for damage. Notify the carrier immediately if damage is observed. Be sure to save the
carton should you ever need to ship the UPM for repair or maintenance.
Placement
This UPM is intended for indoor use only. Although your UPM is very rugged, its internal
components are not sealed from the environment. The UPM must be installed in a
protected environment away from heat producing appliances such as furnaces, radiators,
and heaters. Protect the UPM from exposure to dripping or standing water and high
humidity or condensing air conditions. The location should provide adequate airflow
around the UPM. Provide a minimum 1" clearance on all sides for proper ventilation.
Applying Power to the UPM
For North American versions, connect the power cord to a verified grounded 3 wire receptacle. For
international versions, unplug the cord from your computer and plug into the inlet of the UPM. Then use the
cord supplied with the UPM to connect the UPM to your computer.
For North American versions, verify that the Site Wiring Fault LED is off. Once properly connected and
initially checked, turn on the UPM by pressing and holding the front panel On/Off switch for 3 seconds.
Operational Tests
Observe the front panel of the UPM. The following table shows how the front panel LED should appear
upon start-up.
Indicator Load Battery Receptacle
Monitor Monitor Monitor
LEDs LED's LEDs
Status Off On All On
Voltage Voltage Voltage Battery
Manager Manager Manager
Boost Normal Buck
Off On Off
12
Battery Overload
Mode Weak LED
LED LED
Off Off Off