STERWINS 1300 WT50 SM5I-3 Manual De Instrucciones página 124

Idiomas disponibles

5. BEFORE FIRST USE

Preparing the discharge line

• The discharge line (min. 19 mm (3/4")) must be connected to the discharge connector

either directly or with the aid of a standard adaptor

• With the right couplings it is also possible to use a 13 mm (1/2") delivery hose. The smaller

delivery hose results in a lower delivery rate.

• During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves,

etc.) in the discharge line so that the air can escape without obstruction.

6. OPERATION

DANGER! Risk of injury due to electric shock.

Warning! Do not plug in before installation is fully completed!

Setting up your pump

• Place the pump on a flat firm surface to ensure safe operation

• Remove the connectors caps

Connecting the intake line

• Screw the standard connector

• Assemble the intake line using a standard connector

assembly is tight enough as a leaking intake line will draw in air instead of water.

• If the water is not so clear, add a filter between the suction connector and intake line.

20151214 SPECIFICATIONS 1300 WT 50 SM5I-3.indd 124

and clamp

from the connectors

onto the suction connector

124

, and store them.

and clamp

. Make sure the

14/12/15 12:19