Publicidad
Idiomas disponibles
Idiomas disponibles
45º bevel - Right
Max. Width 7.9" (200.7 mm) Result Height 1.1" (28 mm)
Max. Height 1.6" (40.6 mm)
Result Width 7.1" (180.3 mm)
Your saw is capable of cutting baseboard moldings 0.9" (22.9 mm) thick by 6" (152 mm) tall
on a 45º right or left miter.
NOTE: Your saw is capable of cutting the following once a special set-up procedure is
followed (see Special Cuts).
0º miter
height 1.5" (38.1 mm)
width 10" (255 mm)
45º miter
height 1.5" (38.1 mm)
width 7.5" (190.5 mm)
DRIVE
120 Volt Motor
1675 Watts (max in)
15 Amp Motor
3800 RPM
Cut Helical Gears
Multi-V Belt
Roller Bearings
Automatic Electric Brake
Carbide Blade
FIG. 2
LOCK DOWN
PIN
0º BEVEL STOP
ADJUSTMENT
SCREW
BENCH MOUNTING
MITER SCALE
HOLES
Familiarization
Your miter saw is fully assembled in the car ton. Open
the box and lift the saw out by the con venient carry ing
handle, as shown in Figure 1A. Place the saw on a
smooth, flat surface such as a workbench, strong
table or D
to become familiar with the saw and its various parts.
The section on adjus tments will refer to these terms
and you must know what and where the parts are.
CAUTION: Pinch Hazard. To reduce the risk of
injury, keep thumb underneath the handle when
pulling the handle down. The lower guard will move
up as the handle is pulled down which could cause
pinching. The handle is placed close to the guard for
special cuts.
OPERATING
HANDLE
DW716
CARRY HANDLE
GUARD
MOTOR END CAP
MOTOR
HOUSING
BEVEL SCALE
RIGHT SIDE
FENCE
FENCE LOCK
KNOB
KERF
PLATE
DUST
SPOUT
BEVEL LOCK
KNOB
0º BEVEL
OVERRIDE KNOB
MITER
LOCK LEVER
5
WALT miter saw stand. Examine Figure 2
E
OPERATING
TRIGGER
HANDLE
SWITCH
LOCK DOWN
PIN
45º
45º BEVEL
BEVEL STOP
OVERRIDE
ADJUSTMENT
LEVERS
SCREW
FIG. 1A
TM
XPS
ON/OFF SWITCH
(DW716XPS ONLY)
LEFT SIDE
FENCE
FENCE LOCK
KNOB
HAND
INDENTATIONS
BLADE
BEVEL STOP
WRENCH
33.9º PAWLS
Publicidad
