Publicidad
Idiomas disponibles
Idiomas disponibles
4. Push the On/Off button to start and stop the
operation.
a) Push "I" to start the operation.
b) Push "A" for automatic operation start. Refer to
Automatic start function (Only 230V DE 110 SH
and DE 110 H) on page 12 .
5. To stop the operation, push the On/Off button. The
button goes off when you stop the operation.
6. Push the "0" on the main switch to stop the product.
7. Disconnect the product from the power socket.
Hour meter (DE 110 H/DE 120 H)
The hour meter shows the total operation time of the
product in hours.
To remove dust particles from the
prefilter during operation
The filter purge procedure cleans the prefilter from
unwanted material. Do the procedure in these situations:
•
Stop the product to let the dust fall into the Longopac
bag.
•
Before a work stop or at the end of each work day.
If the product is off for a while, it gives the dust
more time to fall down. This makes the filter purge
procedure more powerful.
•
When the suction is not sufficient.
•
Before installation of a new Longopac bag.
•
When the prefilter clogged alarm goes off.
1. Start the product. Refer to
SH on page 13 or To start and stop DE 110 H/DE
120 H on page 13 .
14
To start and stop DE 110
2. Close the air flow that moves through the air intake
with the air intake plug or the intake valve to make
vacuum.
3. Wait 5 seconds until vacuum is made, then push the
filter purge button. Do this step 3 to 5 times. It is
important to let the product make vacuum between
each button push.
X 3-5
If the suction is not sufficient after this procedure, it is
necessary to clean the prefilter with water. Refer to .
To install a new Longopac bag cassette
CAUTION:
you install a new Longopac cassette. Refer
To remove dust particles from the prefilter
to
during operation on page 14 .
1. Put the Longopac cassette around the inner edge of
the Longopac holder.
2. Remove the 4 straps after you put the Longopac in
the holder.
Clean the prefilter before
1587 - 011 - 06.03.2023
Publicidad
