Husqvarna DE 110 H Manual De Usuario página 16

1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties.
Introduction
WARNING:
related accidents occur during the
troubleshooting, servicing and maintenance
as the operator must be in the risk area of
the product. The operator must be careful,
make a plan and prepare the work to
prevent accidents.
16
A
Product
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac bag cassette on page 14 .
5. Obey local regulations for disposal of the full
Longopac bag.
To do after completed work
1. Do the filter purge procedure. Refer to
dust particles from the prefilter during operation on
page 14 .
2. Stop the product, refer to
SH on page 13 or To start and stop DE 110 H/DE
120 H on page 13 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 15 .
4. Clean the product. Refer to
page 18 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 24 .
Maintenance
To start and stop DE 110
To clean the product on
WARNING:
do maintenance, make sure that the motor
switch and the pump switch are in the Off
positions. Disconnect the power cord and
remove the pump cable.
1587 - 011 - 06.03.2023
To install a
To remove
To discard a full
To
Before you