Husqvarna DE 110 H Manual De Usuario página 22

Warnings on the control panel (DE 110 H/DE 120 H)
CAUTION:
if the red light comes on. If the initial solution
does not remove the error, speak with an
Symbol Signal
Buzzer signal
and the red
light comes on.
The red light
flashes.
Red light
comes on.
Red light
comes on.
Yellow light
comes on.
Red light
comes on.
Error codes
Error
Error
code
HEPA filter miss-
2
ing.
Low supply volt-
3
age.
22
Do not operate the product
Cause
The prefilter is clogged.
Incorrect hose is connected or
selected in the control panel.
The hose is damaged or com-
pressed.
The hose is clogged.
The main vacuum hose is dis-
connected.
The HEPA filter is missing, full or
damaged.
The control unit is damaged.
Too high ambient temperature.
Warning.
The HEPA filter is almost full.
The HEPA filter is full.
Description
Product shuts down/does not
start.
+ Warning light on HMI.
+ HEPA symbol on HMI.
Low performance (low air flow/
vacuum).
approved service agent before you operate
the product again.
Solution
Do a filter purge procedure, refer to
move dust particles from the prefilter during
operation on page 14 .
Attach correct hose or select the correct
hose dimension on control panel.
Replace the hose.
Clear the hose.
Let an approved service agent repair the
product.
Install the HEPA if missing. Do a check of the
HEPA filter, replace if necessary. Refer to
replace the HEPA filter on page 19 .
Let an approved service agent repair the
product.
Make sure that the ambient temperature is in
specified range when you use the product.
Look at the operation record of your Husq-
varna fleet app or speak to an approved
service agent.
Replace the HEPA filter if necessary.
Replace the HEPA filter.
Probable cause(s)
HEPA filter is missing or dam-
aged.
Too low voltage in grid/power
supply.
To re-
To
Action(s)
Assemble or replace
the HEPA filter.
Make sure correct
grid/power supply is
used.
1587 - 011 - 06.03.2023