Heat Source Check; Electric Dryers; Gas Dryers - ALLIANCE SWD619N Instalación/Operación

Heat Source Check

Electric Dryers

Close the loading door and start the dryer in a heat
setting (refer to Operation section). After dryer has
operated for three minutes, the exhaust air or exhaust
pipe should be warm.

Gas Dryers

IMPORTANT: This operation is to be conducted
by qualified personnel only.
To view the burner flame, remove the lower front
panel of the dryer.
Close the loading door and start the dryer in a heat
setting (refer to Operation section). The dryer will
start, the igniter will glow red and the main burner will
ignite.
IMPORTANT: If all air is not purged out of the gas
line, the gas igniter may go off before the gas is
ignited. If this happens, after approximately two
minutes the igniter will again attempt gas ignition.
IMPORTANT: If igniter does not light, make sure
gas is turned on.
1 Closed Position
2 Shut-Off Valve Handle
3 Air Shutter Lockscrew
4 Air Shutter
801539
1
6
5
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
After dryer has operated for approximately five
minutes, observe burner flame. Adjust the air shutter
to obtain a soft, uniform blue flame. (A lazy yellow-
tipped flame indicates lack of air. A harsh, roaring,
very blue flame indicates too much air.) Adjust the air
shutter as follows:
1. Loosen the air shutter lockscrew.
2. Turn the air shutter to the left to get a luminous
yellow-tipped flame, then turn it back slowly to
the right to obtain a steady soft blue flame.
3. After the air shutter is adjusted for proper flame,
tighten the air shutter lockscrew securely.
4. Reinstall the lower front panel.
For personal safety, lower front panel of
dryer must be in place during normal
operation.
After dryer has operated for approximately three minutes,
the exhaust air or exhaust pipe should be warm.
3
2
5 1/8 in. (3.1 mm) Pipe Plug
(For checking manifold pressure)
6 Open Position
Figure 21
Installation
WARNING
4
W288
D700I
27