Before You Call For Service - ALLIANCE SWD619N Instalación/Operación

Before You Call for Service

You may save time and money by checking the
following:
If the Washer:
Won't Won't
Fill Start
•
• •
• •
•
•
•
•
If the Dryer:
Does Does
Not Not
Start Heat
•
•
•
•
•
• •
•
•
•
•
801539
Won't Won't Won't
Tumble Spin Drain
• •
• •
• •
• •
•
Does Not Dry
Clothes
Satisfactorily
Insert coin(s) or card.
Be sure the cord is plugged all the way into the electrical outlet.
Close the loading door.
Make sure the controls are in a HEAT setting.
Press the START keypad.
Has the laundry room fuse blown or become loosened, or is a circuit breaker
OFF? The dryer itself does NOT have an electrical fuse.
Has the motor overload protector cycled? Wait 10 minutes and try again.
Gas Dryers Only – Check to see if the gas valve in the dryer (behind the lower
front panel) and the main gas line valve are turned on.
•
Clean the lint filter.
Check the exhaust duct to the outside to see if it is kinked, blocked or needs
•
cleaning.
Check the weather hood to make sure the flappers move freely, are not pushed
•
in or have not been blocked.
• Is the load too small? Small loads may not tumble properly or dry evenly.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Possible Reason
Be sure power cord is plugged all the way into the electrical
outlet.
Close the loading door tightly.
Check the laundry room fuse or circuit breaker.
Turn on the hot and cold water faucets.
Clean the screens in the water mixing valve and the filter
screens in the fill hoses.
Are controls properly set?
Broken drive belt. Call the service person.
• Foreign object trap clogged. Clean foreign object trap.
Press the START keypad.
Insert coin(s) or card.
Possible Reason
Maintenance
Do This to Correct
–
Do This to Correct
–
65