Toto TES201AB Serie Manual De Instalación Y Del Propietario página 11

INSTALLATION PROCEDURE - Connecting Hoses and Cords
Hose Connections
1. Cut the hoses to an appropriate length that
reaches to the connected part.
(Between the spouts and the controller)
(Between the controller and the tank)
Caution
Using a cutter, etc., cut the hoses so that the
cut surface becomes vertical.
2. Insert the hose fully into the controller and
put the hose clamp on the projection of the
joint to anchor the hose securely.
Hose
Hose clamp
Projection of joint
Caution
 Connect the hoses and sensors in the
predetermined pairs.
 When inserting the hoses, pay attention not
to apply strong force to the joint of the tank.
 Pay attention not to bend the hoses.
[ Tank side ]
[ Controller side ]
0.8 gallon (3L) Tank 0.26 gallon (1L) Tank
Liquid soap hose (clear)
Connect it to the tank.
Liquid soap hose (clear)
Connect it to the spout.
Air hose (blue)
Connect it to the spout.
Connect the hoses
and sensors in the
predetermined pairs.
* Connect the single type to
(The sensor does not work in any other
position.)
* Connect the double type to
( does not work.)
11
(special order)
only.
and .