GE Profile PHP9036 Manual Del Propietário página 11

How Induction Cooking Works
The magnetic fields induce a small current in the pan.
The pan acts as a resistor, which produces heat, much
like a radiant coil.
The cooking surface itself does not heat. Heat is
produced in the cooking pan, and cannot be generated
until a pan is placed on the cooking surface.
When the element is activated, the pan begins to heat
immediately and in turn heats the contents of the pan.
Magnetic induction cooking requires the use of cookware
stick, such as iron or steel.
be large enough for the safety sensor to activate an
element.
Cooking Noise
Cookware "noise"
Slight sounds may be produced by different types
of cookware. Heavier pans such as enameled cast
iron produce less noise than a lighter weight multi-ply
stainless steel pan. The size of the pan, and the amount
of contents, can also contribute to the sound level.
When using adjacent elements that are set at certain
power level settings, magnetic fields may interact and
sounds can be reduced or eliminated by lowering or
raising the power level settings of one or both of the
will produce less sound.
settings.
Slight sounds, such as hums or buzzes, may be
produced by different types of cookware. This is normal.
Heavier and uniform material pans such as enameled
cast iron produce less sound than lighter weight multi-
49-2000977 Rev. 1
The cooktop will not operate if a very small steel or iron
is placed on the cooking surface when the unit is turned
knives and other small utensils.
pan material is correct if a magnet sticks to the
bottom.
layered stainless steel pans or pans that have bonded
disks on the bottom of the pan. The size of the pan, the
amount of contents in the pan, and the flatness of the
pan can also contribute to the sound level. Some pots
sound may be heard if the pan contents are cold. As the
reduced, the sound level will go down.
for the burner can produce louder sounds. They can
cause the controller to "search" for the pot and produce
a clicking and "zipping" sound. This can happen when
one burner is running or only when an adjacent burner
pots for each burner. Only measure the flat, magnetic
bottom of the pot.
11