Stihl MS 150 C Manual De Instrucciones página 43

Pull out the starter rope about 15 cm
N
and hold the rope rotor steady.
Take three turns off the rope rotor.
N
Pull the rope out with the starter grip
N
and keep it under tension – then let
go of the rope rotor.
Slowly release the starter rope until
N
it goes slack.
The rewind spring is no longer under
tension when the starter rope is not
wound completely onto the rope rotor
and can be unwound by hand.
MS 150 C
Removing the Rope Rotor
Loosen screw (1) on carrier (2).
N
Carefully pull the carrier (2) off the
N
rope rotor (3).
3
Carefully remove the rope rotor (3).
N
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
Replacing a Broken Starter Rope
1
2
3
Pry the cap out of the starter grip.
N
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie a simple
overhand knot.
Pull the knot back into the grip.
N
Refit the cap in the grip.
N
English
41