Nuna pipa next Manual Del Usuario página 15

Securing Child
Use Infant Insert
We recommend using the full
infant insert while the baby
is under 60 cm or until they
outgrow the infant insert. The
infant insert increases side
impact protection.
After the child is placed into the seat, check whether the Shoulder Harness
Straps are at proper height.
1
- While pressing the harness adjustment button, pull completely the two
Shoulder Harness Straps of the enhanced child restraint. (22)
2
- Unlock the buckle of the harnesses by pressing the red button. (23)
3
- Place the child into the infant carrier module and lock the buckle. (25)
Please refer to (24).
4
- Tighten the shoulder harness straps by pulling the adjustment webbing.
(26)
Make sure the space between the child and the Shoulder Harness Straps is
about the thickness of one hand.
Canopy
1
- Unzip the zipper of the front canopy bow. (27)
2
- Pull the dream drape™ out of the canopy. (28)
3
- Attach the magnets on each corner to the front of the infant carrier module
with magnets. (29)
4
- The canopy window can be opened for ventilation. (30)
13
PIPA next instructions
Remove the infant
insert when the infant's
shoulders no longer fit
comfortably.
Detach & Assemble Soft Goods
see images (31)-(42)
To re-assemble the soft goods, reverse the aforementioned steps.
Installation without Base
1
- DO NOT install this infant carrier module on vehicle seats with Lap Belts.
(43)
2
- This infant carrier module is suitable for vehicle seats with a 3-point
Retractor Safety Belt (without base) only. (44)
3
- Place the infant carrier module onto the vehicle seat where you wish to
put it. Pull the vehicle safety belt out and lock it into the vehicle buckle,
sliding the vehicle lap belt into the side guides of the infant carrier
module. (45)
The infant carrier module can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the infant carrier module
securely. (45)-1
4
- Slide diagonal belt into the rear guide. (46)
5
- Pull the vehicle shoulder belt to fasten the infant carrier module tightly
and securely. (47)
6
- Level line on infant carrier module must be level to the ground when the
infant carrier module is installed. (48)
Tension the vehicle safety belt as much as possible, checking that it is
not loose or twisted.
After installing the infant carrier module, always check that the vehicle
belts are routed correctly and securely fastened into the vehicle buckle.
(49)
14
PIPA next instructions