Features; Assembly - Ryobi DUET FPR300 Manual Del Operador

PRODUCT SPECIFICATIONS
Roller sq. ft. per minute .......................................................................................................................... 58 sq. ft. per minute
Finish sprayer pressure ...............................................................................................................................................5-8 PSI
Tube length ......................................................................................................................................................................12 ft.
Rating .............................................................................................................................................. 120 V~, 5.5 Amps, 60 Hz
KNOw yOUR PAINT SySTEM
See Figure 1, page 12.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
CUT-IN PAD - The cut-in pad provides an easy alternative to
painting in tight places such as window and door molding.
CORNER PAD - Paint corners in one quick stroke with the
corner pad.
DUET™ POwER PAINT TOOL SySTEM - Dual features
allow for two users to use the system together: one can use
the roller while the other uses the cut-in or corner pad.
NOTE: Users cannot spray and roll paint at the same time.
The finish sprayer must be used alone. You can use the paint
roller and either the cut-in pad or corner pads together.
FINISH SPRAyER - The finish sprayer provides a smooth
finish with little overspray.
UNPACKING
This product requires assembly.
 Carefully lift the product from the carton and place on a
level work surface.
wARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.

FEATURES

FORwARD / REVERSE SwITCH - With the switch set on
forward, paint is pulled from the can or bucket and flows
into the roller, sprayer, cut-in or corner pad for easy paint
application. When the switch is set on reverse, paint is pulled
from the roller, sprayer, cut-in or corner pad and puts it back
in the can or cleaning bucket.
HANDLE REST - A convenient resting place on top of the
machine helps keep the work area clean while providing a
temporary resting place for painting accessories.
ON/OFF SwITCH - The paint tool systems features an easy
access on/off switch for convenience and safety.
PAINT CONTAINER / CLEANING BUCKET - The paint con-
tainer / cleaner bucket can be used to hold paint or warm,
water for easy clean up.
PAINT ROLLER - The paint roller accepts any 9 in. roller,
up to 1/4 in. nap.
VARIABLE PAINT FLOw DIAL - The variable paint flow dial
on the handles make paint flow control quick and easy.
TOOL STORAGE - When not in use, store handles in the
slots at the rear of the machine.

ASSEMBLy

 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Duet™ Power Paint Tool System
Paint container / cleaning bucket
Finish sprayer
Paint roller head
Handles (2)
Cut-in pad
Corner pad
Paint tubes (2)
Blower hose
Cleaning accessory
Operator's Manual
7 — English