Publicidad
Idiomas disponibles
Idiomas disponibles
N.B. The connection cable must have the following characteristics: it must be at least type H05 RN-F (resistant to a
temperature of at least 150°), and must have an adequate section for the power of the appliance (see technical data
table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbo
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance for the first frying, it is necessary to clean it carefully, especially the water tub (see
paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
Use the appliance only under surveillance.
- Oil or fat already used are more at risk of catching fire; therefore only use fresh oil or fat for frying.
- The food to be fried must be dry; damp or wet fry cause froth and danger of overflowing.
- Also large quantities of fry cause froth.
- When the oil goes below the minimum level, fire risk is higher.
- Never start up the appliance without oil.
These frying appliances allow to fry potatoes, fish vegetables, etc.
Check to ensure that the oil outlet tap (B) is turned off.
Fill the tub with oil up to the level indicated inside the tub(between min and max).Switch on the switch situated above
the appliance. Turn the knob from"O" into the desired position between 100° and 180°; The white and green lights
come on. The green light indicates the presence of electrical tension. The white light shows that the heating element is
working; when the temperature is reached, it goes out. To turn off the appliance, turn the knob into position "O".
To use the deep fryer with products other than oil (lard, for example) and in any case featuring high thermal inertia, the
thermostat needs to be set at a low value (e.g. 110°C) at the first cycle (starting from cold).
Only after the entire mass has dissolved can the thermostat be set at the maximum level
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
GB
EQUIPOTENTIAL
.
STARTING UP
INSTRUCTIONS FOR USE
TURNING ON
The user should be equipped with a suitable container for the oil.
Insert the outlet pipe as shown on the drawing and place the
container in position. Push the safety device (A) upwards and
move lever (B) to the symbol.
Important: pay attention to the clearance between the appliance
and the edges of the stands.
CLEANING AND MAINTENANCE
20
IE
EMPTYNG THE TANK
Publicidad
