Domair FD-40M Instrucciones De Uso página 28

Assembly
1. Front grille 2. Impeller 3. Power unit 4. Oscillation controller
5. On/Off button + speed selector. 6. Power unit mounting screw
7. Power unit tilt adjustment knob 8. Power cable
9. Height-adjustment wheel 10. Inner tube 11. Base
FAN HEAD ASSEMBLY
1- Remove the 4 screws located
around the axis of the power unit.
Position the rear grille on the motor
unit then tighten the 4 screws to clamp
the grille in place correctly.
2- Fit the impeller on the motor axle,
then firmly screw in the impeller
clamping screw as shown in the
picture. After tightening, check that the
impeller rotates freely by turning it by
hand.
REV 1 – 09 09 19 Fabriqué en Chine Page 28