Webasto ProCore Edge 30 Guia De Instalacion página 9

Installation Guide
3.5 – Floor stand Installation
Bottom Bracket
10-Bay Charger
Figure 6 – Floor Stand
1. Remove the six M5 screws on the top panel of the charger (Figure 2) with a TORX TX25 and
remove the panel.
Webasto Charging Systems, Inc.
DANGER
CONNECTION TO MAIN POWER
• Only qualified service personnel should remove the cover.
• Only a qualified electrician is to make electrical connections!
• Make sure that the service AC input voltage is powered off before
wiring the charger.
• This device does not contain any user serviceable parts.
DANGER
CONNECTION TO MAIN POWER
• Ensure that the AC power cables to be used are disconnected from
the AC power supply before continuing!
• Verify that there is no connection to the AC before opening the cabinet,
which exposes AC wiring, and making terminal connections!
• Disconnect all power before servicing!
WARNING
RISK OF FIRE
• Use VAC input (indicated above) only on circuits with a branch circuit
protection in accordance with the NEC NFPA 70 to reduce the risk of fire.
• These circuits (maximum CB size) also are to be consistent with the
supply current (input amps) indicated in section 2 for the respective
number of modules (6-10) and voltage (48V or 80V) of fitted modules
and cabinet size (10 bay).
• Ensure that the AC wiring (minimum AC input wire size [AWG]) indicated
in section 2 to meet NEC requirements.
• Refer to section 2 also for AC input voltage specifications.
Figure 7 – Predrilled
Holes for Bolting
Base to Floor
Figure 8 – Optional
Pogo Stick
VAC Input
Three-phase 480VAC
Page 9 of 12
ProCore Edge 30 North America
Figure 9 –
Charger on
Floor Stand
Figure 10 – Bottom Bracket
M5 Screw
Torque: 35.4 in-lb (4 Nm)
5912526 A01