Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
H. Silicone seal & fixed
Bathtubs installed in an alcove installation require a raised flange to prevent
water from seeping past the tub and into the wall. The bathtub should be
installed with a tile flange kit (Not Supplied). The flange kit is a long plastic
strip that fits onto the rim of the tub to provide the leak protection needed.
The tile flange should be installed on the tub before it is placed in the alcove.
Install the tile flange along all sides of the tub where the wall will be. Measure
to fit and miter cut the flange corners. The flange should be attached to the
tub with a construction adhesive. Once the tub is in place to be installed and
flange kit mounted, fasten the flange to studs using fasteners.
CAUTION:
Never attempt to nail or screw through the bathtub as this will result
in product failure and will void the warranty.
I. Clean after installation is complete
When cleaning after installation, do not use abrasive cleaning implements to avoid damaging and tarnishing the surface of the tub. Clean the surface
of the tub with warm water and a non-aggressive liquid cleaner.
Difficult-to-remove stains can be cleaned with alcohol. The plaster can be scraped off with a thin wooden knife. For residual grout, use a damp cloth
with liquid laundry detergent.
CAUTION:
Under no circumstances use wire brushes, metal sponges, steel wool or scouring pads on any part of the tub, or solvents that contain
petroleum distillates such as acetone, benzene or abrasive cleanser on any part of the tub. Use caution with ammonia and chlorine-based
cleaners on metallic trim components. The metal surface is a plated finish and these types of cleaners can erode or discolor the finish.
CLEANING THE BATHTUB WITH THE ABOVE ITEMS WILL VOID THE WARRANTY!!!
OPERATING INSTRUCTION
Door Operation
1. Close the door:
1.1. Close the door.
1.2. Place the inswing door lever in closed position.
2. Open the door:
2.1. Place the inswing door lever in opened position.
2.2. Open the door.
CAUTION:
WHEN NOT IN OPERATION KEEP DOOR UNLOCKED TO
MAINTAIN GASKET SHAPE. IF THE DOOR IS LEFT IN THE
CLOSED POSITION FOR LONG PERIODS OF TIME THE DOOR
GASKET WILL LOSE ITS FLEXIBILITY AND WILL NOT RETAIN
ITS SEALING CAPABILITY.
Two Handle Roman Faucet
A: Hot water lever. Controls the flow of hot water.
B: Fill Spout with diverter. The hot and cold water levers mix the desired water
temperature which flows into the bathtub through the fill spout. When water
is flowing through the spout lift the diverter up to divert water to handheld
shower.
C: Cold water lever. Controls the flow of cold water.
D: Handheld shower. By turning the dial, you can switch between 6 water
spray modes.
CAUTION:
When you first use the bathtub every day, be certain tub drain is
open as first water coming from spout may be too cold or too hot.
Carefully test water temperature by slowly moving hand into
water stream.
Nail
Wall Stud
Tile Flange
14
Dry Wall
Tile
Silicone
Bathtub
OPEN
CLOSE
Pull diverter up for
handheld shower
Push down for
fill spout
Switch the
water mode
Publicidad
