Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTION
Horizontal Drain
Rotate the operator clockwise to open the drain.
Rotate the operator anticlockwise to close the drain.
When the water is over the maximum water level,the excess water will
drain by overflow.
CLEANING & MAINTENANCE
Water jets and pipe circulation systems
Water jets and pipe circulation systems should be flushed before first use and on a monthly basis when product is under normal use. Below are the
recommended procedures for cleaning:
• Fill the tub with hot water 2-3 inches above the jets and add 2-3 teaspoons of low foaming detergent such as dishwashing machine detergent.
• Turn on jet massage system and run for 10 minutes.
• Drain tub completely.
• Fill tub with cold water above jets.
• Turn on jet massage system and run for 15 minutes.
• Drain tub completely.
• Cleaning the "suction cover": Clean and remove any hair or lint from the suction cover. On a monthly basis, unscrew the suction cover and clean
away any hair, lint or debris from the cover and housing, then remount the cover in place. Some suctions are not designed to be removed; only
suctions that have screws on the cover, visible from the inside of the tub, can be removed.
WARNING:
Never operate the unit with the safety suction cover off.
CAUTION:
Do not run the water jets system dry.
Bathtub body
After each use, rinse all exposed surfaces with warm water, then wipe tub completely dry.
Once a week, wash all exposed surfaces of the bathtub with a mild solution. Oily or greasy spots can be lifted with denatured alcohol.
Door seal
Periodocally wipe down the door seal and door jamb to maintain the integrity of the water seal. In order to keep the door seal and door jamb clean and
not accumulate dirt or debris of any kind, clean seal and jamb with a mild detergent and warm water using a soft cloth.
THE DOOR SHOULD BE LEFT OPEN WHEN THE BATHTUB IS NOT IN USE. This allows the door seal to relax and resume its natural shape and
flexibility.
CAUTION:
Must empty the bathtub and the water in the pipe during the winter use. It is possible that the pipes could freeze, rupturing the pipes or
equipment.
Use no water other than standard tap water. The use of well water or spring water could cause corrosion, which could lead to leaks.
Bathtub should be prevented irradiating by ultraviolet light or bright light, otherwise it will accelerate the aging of surface of the bath.
Keep far away from cigarette butts, hair dryer and other heat sources, the product will be damaged due to contact with high temperature.
Do not strike the surface of the bathtub with hard objects. Doing so could crack or scratch the bathtub or cause leaks that damage
household property.
When the product is in operation do not cut off any connection lines. Doing so may cause product leakage, electric shock, or other
accidents.
CLOSE
15
OPEN
CLOSE
OPEN
Drain plunger
Drain operator
with overflow
Publicidad
