Publicidad
Idiomas disponibles
Idiomas disponibles
Option 2: Search for "Xiaomi Home" in the
App Store or Google Play or scan the QR
code to download and install the app.
❷ Reset WiFi
1. Open the top cover and find the WiFi indicator.
2. Press and hold the
and
buttons until you
hear the "Resetting WiFi" voice alert. The reset
is complete when the WiFi indicator flashes
slowly. The robot will then wait for a connection.
Note:
If you cannot connect to the robot due to your
router configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new device.
❸ Add Device
Open the Roborock App, tap the "Scan to
Connect" button or the "Search for device"
button, or open the Xiaomi Home app,
tap "+" in the top right corner and add the
device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app
updates. Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 30 minutes for a
connection, WiFi will be automatically disabled. If you
want to reconnect, reset the WiFi before proceeding.
Instructions for Use
C
On/Off
Press and hold the
button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode.
Press and hold the
button to turn off the
robot and complete the cleaning cycle.
Note:
The robot cannot be turned off when it is being
charged.
Filling the Water Tank
C1
Remove and open the clean water tank and
fill the tank with water. Close the lid, lock the
latch, and fit the tank back in place.
Notes:
• To prevent corrosion or damage, only use the Roborock
branded floor cleaner in the water tank.
• Do not add too much cleaning fluid to prevent the robot
from working improperly due to slipping.
• To avoid water tank deformation, do not place hot water
in the tank.
• If water marks remain on the water tank, wipe them
clean before reinstallation.
Starting Cleaning
C2
Press the
button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room into
zones, first draws out zone edges, and then
fills the zone in a zigzag pattern. In so doing,
the robot cleans all zones one by one,
efficiently cleaning the house.
07
C2-1—Zone 1 – Cleaned
C2-2—Zone 2 – Cleaned
C2-3—Zone 3 – In Progress
C2-4—Zone 4 – Next Zone
Notes:
• To allow the robot to automatically vacuum and return
to the dock, start the robot from the dock. Do not move
the dock during cleaning.
• Cleaning cannot start if the battery level is too low.
Allow the robot to charge before starting the cleanup.
• If cleaning is completed in less than 10 minutes, the
area will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging,
the robot will resume where it left off.
• The robot will retract mop cloth mount when cleaning
the carpet. You can also set the carpet as a no-go zone
in the app to avoid it.
• Before starting each mopping task, make sure that the
mop cloths have been properly installed.
Spot Cleaning
Press and hold the
button to start spot
cleaning in pause mode.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) x 1.5 m (4.9 ft) square area centered
on itself.
Note:
After spot cleaning, the robot will automatically
return to the starting point and enter Standby mode.
Pause
When the robot is running, press any button
to pause it, press the
button to resume
cleaning, press the
button to send it back
to the dock.
Note:
Placing a paused robot on the dock manually will
end the current cleanup.
Publicidad
