Holmatro GCT 41 EVO 3 Serie Manual Del Usuario página 44

EN
5.9 GCT 41**, attachment of pulling accessories
Refer to Fig. 6.
• Open the spreading tips fully.
• Place the pulling attachments correctly so that the shortening hooks point with their openings
upward.
• Attach the chains to the objects so they can not slip off.
• Pull the chains tight and connect them to the pulling attachments.
• Close the spreading tips.
6 Use
6.1 General
The equipment of a rescue system must always be ready for use. That means the equipment must be
checked and inspected directly after use, before it is put away.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use of
all equipment of the system you are going to work with.
6.2 Before use
• Before use, always check the State Of Charge of the battery pack. See section 3.6.
6.3 Changing the battery pack
The battery pack has a LED indicator that indicates the approximate battery level (the State Of Charge).
No lit LED indication will be shown during the operation of the tool.
CAUTION
• Many cycles in a short time may cause temperature increase above allowed limits. The
battery protection will shut down the battery until the temperature lowers to a value within
allowed limits.
• Using the battery pack at temperatures above 45 °C (113 °F) reduces the life time of the
battery pack.
Refer to Fig. 11.
• Switch off the tool using the on/off switch.
• Remove the battery pack.
• Place a new battery pack on the tool.
• Switch on the tool using the on/off switch.
NOTICE
It is highly recommended to have at least one fully charged spare battery pack available at
all times.
44 916.001.670_001 GCT 41** EVO 3