Tool Movement - Holmatro GCT 41 EVO 3 Serie Manual Del Usuario

NOTICE
To protect the battery pack, the tool will stop as soon as the battery pack gets empty. It might
happen that at that time the tool is fixated. To remove the tool it is best to replace the battery
pack by a fully charged one. When this is not possible the battery pack can be activated
again by pushing the SOC indicator button. To prevent damaging the battery pack, this can
only be done a limited number of times.
6.4

Tool movement

The cutting blades open and close relatively quickly until they encounter resistance. Then the pump will
build up the required pressure for spreading, cutting, pulling or squeezing.
WARNING
Take extreme care during tool movement. Because of the enormous power of the tool parts
of the body can easily be crushed or pinched.
6.5 Cutting
See Fig. 8 and Fig. 9.
CAUTION
Do not cut hardened fastenings, bolts, etc. because this can damage the blades.
• Open the blades.
• Place the tool with opened blades perpendicular to the object to be cut.
• Place the object to be cut as deeply as possible in the cutting opening.
• Close the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
6.6 Squeezing
• Open the blades of the tool.
• Place the blade tips over the object to be squeezed.
• Position the load 25 mm from the end of the tips. Use full width of the tips.
• Close the blades of the tool.
CAUTION
When using tool model (G)CT 5160, always use the spreading tips. Make sure the lock pins
stay locked.
6.7 Spreading
CAUTION
When using tool model (G)CT 5160, always use the spreading tips. Make sure the lock pins
stay locked.
6.7.1 Initial opening is sufficient
• Close the blades completely.
• Place both blade tips between the parts to be spread.
GCT 41** EVO 3 916.001.670_001
EN
45