After Use - Holmatro GCT 41 EVO 3 Serie Manual Del Usuario

EN
• Position the load 25 mm from the end of the tips. Use full width of the tips.
• Force the parts apart by opening the blades.
6.7.2 Initial opening is insufficient
• Open the blades.
• Place one blade tip in the opening. Use full width of the tip.
• Close the blades until the material is clamped.
• Bend the clamped material out of the way.
• Repeat this procedure until there is sufficient space to place both blade tips.
• Force the parts apart by opening the blades.
6.7.3 No initial opening
• Use a different tool or accessory to make an opening.
• Continue with the steps above, depending on the opening created.
6.8 Pulling
NOTICE
Not all tools have been designed for pulling. See section 3.5 for the tools that can be used
for pulling.
WARNING
The pulling accessories are intended solely for the horizontal movement of loads.
Make sure the lock pins stay locked.
Hoisting is not permitted with these accessories.
WARNING
Make sure that the load is always supported from underneath. Continuously check the
behaviour of the load. Make sure that the tool can move freely during pulling and always
remains in a straight line between both pulling attachments.
• Fully open the blades.
• Make sure the openings of the shortening hooks do not point down.
• Attach the pulling chains to the objects so that they cannot slip off.
• Pull the chains tight and hook them to the pulling attachments.
• Close the blades.
6.9

After use

6.9.1 Inspection
• Check the battery level. Recharge the battery pack, if necessary. See section 3.6.
• Check the unit for completeness, leaks and damage. Do not use the unit if it leaks or is damaged
and contact the Holmatro dealer.
• Check the accessories used for completeness and damage. Replace them if the damage is
considerable.
• Inspect the tips. Replace them if the damage is considerable.
• Check the operation of the deadman's handle. It must return to the neutral position when you
release it.
• Check that the carrying handle is firmly attached.
46 916.001.670_001 GCT 41** EVO 3