Holmatro GCT 41 EVO 3 Serie Manual Del Usuario página 48

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 105
EN
Possible cause
The led of the on/off switch flashes quickly. The electric motor is too hot. Wait for the temperature of
7.3
The green LED of the tool does not light up when the tool is switched on
/i
Possible cause
The battery pack is not locked.
The battery pack is in the sleep mode. This
happens when tool is not used for about 10
minutes.
7.4
The useful operating time between the individual charging cycles of the
battery pack is less than 5 minutes
/i
Possible cause
The battery pack is defective.
7.5
The deadman's handle is jammed or doesn't return automatically to the
neutral position
/i
Possible cause
The deadman's handle is damaged
externally.
The deadman's handle is faulty.
7.6
The light is weak or gives no light at all
/i
Possible cause
The battery is (almost) empty.
7.7
The cutting is poor
/i
Possible cause
The spreading arms/blades are damaged.
The tightening torque of the centre bolt is
incorrect.
48
Solution
the tool to decrease.
Solution
Remove the battery pack and slide it in the tool again
until the battery pack lock snaps tight.
To activate the battery pack again:
Press the SOC indicator button, or
Operate the on/off switch again, or
Reinstall the battery pack.
Solution
Replace the battery pack.
Solution
Have it repaired by a Holmatro Certified Technician.
Have it repaired by a Holmatro Certified Technician.
Solution
Replace the battery.
Solution
Sharpen or file the cutting edge of the blades in the
correct shape.
Tighten the bolt to 50 Nm.
916.001.670_001
GCT 41** EVO 3

Publicidad

Tabla de contenido
loading

Tabla de contenido