Operating the rechargeable battery
Steel with low thickness
NF metals or workpieces with an uneven surface
Operating the rechargeable battery
Inserting the rechargeable battery
Removing the rechargeable battery
46
When drilling into low thickness steel, an additional steel plate (mini-
mum dimensions 100 x 200 x 20 mm) must be placed under the
workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling into NF metals
or into workpieces with an uneven surface.
NOTE
►
BDS offers a range of accessories with special clamping
devices for tubes and non-magnetic materials.
Push the lid of the battery compartment (6) to the side and
remove the lid.
Guide the rechargeable battery into the battery compartment
from above. The contacts of the rechargeable battery point
downwards.
Close the lid of the battery compartment again.
Push the lid of the battery compartment (6) to the side and
remove the lid.
Actuate the the lifting mechanism with the cross-handled Allen
key (B) supplied to lift up the rechargeable battery.
Lift the rechargeable battery out of the battery compartment.
Close the lid of the battery compartment so that no foreign
bodies can fall in to the battery compartment.
AkkuMAB 3000