Publicidad
Idiomas disponibles
Idiomas disponibles
that has the capacity to handle the current the product
will draw. An undersized cord will cause a drop in line
voltage, resulting in overheating and loss of power. Use
the chart to determine the minimum wire size required in
an extension cord. Only round jacketed cords listed by
Underwriter's Laboratories (UL) should be used.
When working outdoors with a product, use an
extension cord that is designed for outside use. This
type of cord is designated with "W-A" or "W" on the
cord's jacket.
Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
A proper extension cord is available at an authorized
service center.
It is possible to tie the extension cord and power cord in
a knot to prevent them from becoming disconnected
during use. Make the knot as shown in the figure, then
connect the plug end of the power cord into the
receptacle end of the extension cord. This method can
also be used to tie two extension cords together.
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Total Length of Cord in Feet
Amp Rating
More
Not More
25' (7.6
Than
Than
0
6
6
10
10
12
Keep the extension cord clear of the working area.
Position the cord so that it will not get caught on lumber,
tools, or other obstructions while you are working with a
power tool. Failure to do so can result in serious
personal injury.
Check extension cords before each use. If damaged
replace immediately. Never use the product with a
damaged cord since touching the damaged area could
cause electrical shock resulting in serious injury.
4
SYMBOLS ON THE PRODUCT
Some of the following symbols may be used on this tool.
Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate
the tool better and safer.
English
(meters)
50' (15
100'
m)
m)
(30.4 m)
18
16
16
18
16
14
16
16
14
Symbol
Name
V
Volt
A
Amperes
Hz
Hertz
W
Watt
min
Minutes
/min
Per Minute
Alternating
Current
Direct Cur-
rent
No Load
n o
Speed
Safety Alert
Eye Protec-
tion
WARNING
--- Wet Con-
ditions
Read Opera-
tor's Manual
Maintain
Safety Devi-
ces
Looking Be-
hind While
Backing
DANGER ---
Keep Hands
and Feet
Away
DANGER ---
Keep By-
standers
Away
5
Explanation
Voltage
Current
Frequency (cycles per
second)
Power
Time
Revolutions, strokes, sur-
face speed, orbits etc.,
per minute
Type of current
Type or a characteristic
of current
Rational speed, at no
load
Precautions that involve
your safety.
Always wear eye protec-
tion with side shields
marked to comply with
ANSI Z87.1 when operat-
ing this equipment.
Do not expose the prod-
uct to rain or moist condi-
tions.
To reduce the risk of in-
jury, user must read and
understand operator's
manual before using this
product.
Do not open or remove
safety devices while the
tool is running.
Look down and behind
first to avoid tripping
when pulling back.
To reduce the risk of in-
jury, keep hands and feet
away from rotating parts.
Do not operate unless
discharge cover or grass
bag is in its proper place.
If damaged, replace im-
mediately.
Do not mow when chil-
dren or others are near-
by.
EN
Publicidad
