Publicidad
Idiomas disponibles
Idiomas disponibles
8.4. Installation steps:
1
9. Power Connection
1
CONNECTION TO THE CIGARETTE LIGHTER SOCKET
Please note: the OBU must always be connected to the power supply!
8.2. Connection to the cigarette lighter socket
Connect the charging cable supplied to the cigarette ligher socket and make sure:
• The plug is securely connected.
• The charging cable is routed in such a way that the driver is not obstructed.
8.3. Fixed power connection
1. Use the cigarette lighter cable supplied. Make sure the cable is long enough, then remove the lighter
plug and any excess cable.
2. Locate the connection points in the vehicle using the diagram below. The black wire should be connected
to the vehicle ignition.
3. Before connecting the cables to the vehicle, install a five-amp fuse in series with the power wires (red
and black wires). If the vehicle's power supply is already fused, this step is not necessary.
4. Finally, connect each wire to the connection points you have identified (battery, ignition and earth).
INFORMATION
Without a power connection, the OBU in full charge can operate for
off, the OBU is offline and toll payment is not possible anymore. If the vehicle continues to pass through
tolled sections, it may be enforced and any fees or fines must be paid by the user.
10. First Switch-On
1
shielded bag
22
2
Remove the
sticker on the
backside!
2 3 4 S
old OBU
3
Place the device
like indicated on
the picture!
2
FIXED POWER
Red
Black
White earth
This installation should be carried out by a qualified
vehicle workshop.
2 to 3 hours.
2
4
Press OBU for a
couple of seconds
against the
window
+12V/+24V power
+12V/+24V ignition
As soon as the display turns
Publicidad
