Frizzlife PX500-A Manual Del Propietário página 6

Model: PX500-A
5. Installation Steps
Precautions:
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection.
Testing was performed under standard laboratory conditions, actual performance may
vary.
For cold water use only.
This filter must be protected from freezing, which can cause cracking of the filter and
water leakage.
Do not allow children under 3 years of age to have access to small partsduring
installation.
The installation must comply with all applicable state and local regulations.
Step 1: Cut and Soften the 3/8" white tubing
Please cut the 3/8" white tubing in proper length, make sure cut them squarely
and cleanly. (Fig.1)
Put one end of the tubing into boiled water for 5 seconds to soften itself.(Fig.2)
Fig.1
Step 2: Connect three-way feed water valve (3/8" or 1/2")
Load the 3/8" tubing through the nut. (Fig.3)
Connect the end of 3/8" tubing that has been softened into the 3-way feed
water valve. Make sure push and squeeze the tubing to the very end.(Fig.4)
Use a wrench to tighten the nut, please do not over tighten. (Fig.5)
Note: If the cold water pipe is 1/2", please connect one part of converter
!
to the angle valve and connect another part of converter to the pipe
before proceeding to the next step. (see Fig.6)
Fig.2
EN