Stryker Quantum 2000 Manual De Usuario página 7

Idiomas disponibles

SET-UP AND OPERATION

After a 15-second warm-up period, the light output will stabilize at its

normal intensity.

1. Plug the Quantum 2000 Light Source into a hospital-grade receptacle.

2. Turn the light-intensity control knob to its minimum position. Plug the fiber

optic bundle into the illuminator port and connect the opposite end to the

instrument.

3. Turn the power switch to the on position. The lamp will take 15 seconds to

complete its warm-up cycle.

4. Set light intensity to desired level.

5. Turn unit off when not in use.

NOTE: Do not restart lamp immediately after turning off.The lamp

may fail to start. If this occurs, turn the power switch off and wait

15 seconds before restarting the Quantum 2000 Light Source.

Q2000