Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Hardwired installation
Installation of your Free2move Charge Wallbox charger with a permanent power supply.
Bottom
Connection
Power supply/wiring
Follow our recommendations
for location and positioning
the charger (page 9).
Make sure to power off any connections!
Rear
Connection
Determine wiring entry
Before hardwire installation, determine which
entry port you will be using for your power
supply wiring or conduit. Your charger can be
connected from either the rear or bottom entry
ports. Choose the most appropriate connection
based on the placement of your wiring or
conduit.
Be sure to note that the power supply entry for
either port will be on the left side of your charger.
Ensure that you locate your charger so that the
power supply wiring or conduit is accessible on
the left side of your charger.
Placement
Using a wall stud finder, find the wall stud
nearest to and on the right side of the power
supply wiring.
Mark a vertical line approximately 20" (50cm)
in length in line with the wall stud at the
approximate height of your mounting.
Alternately you may find a suitable location on
a solid wall.
Preparing your charger
Hardwire installation requires opening your
charger to access and connect the hardwire power
supply connection.
• Remove the cover frame from the front of your
charger by removing the bottom screw that
affixes the frame to the cover.
• Remove the four corner screws on the cover and
carefully lift the cover.
• From the cover, carefully detach the ribbon
cable. Set the cover aside.
T20
ø4 x 10mm
EN
15
Publicidad
