Publicidad
Idiomas disponibles
Idiomas disponibles
3.1.1 s
Afety guArd
f
it ProtectiVe guArd
The bolts and the grooves must align.
A
djustment of sAfety guArd
Bring the safety guard into the desired working position.
For fastening the screw must be tightened down. To re-
lease, turn screw back approx. ½ rotation. Safe operation
is guaranteed only with tightened screw. If the cowl can
no longer be turned with ease, the locking mechanism
must be cleaned.
r
emoVAl of sAfety guArd
If necessary, release screw with Allen key. Bring bolt and
groove into alignment and remove the safety guard.
c
leAning of locKing mechAnism
Remove safety guard as mentioned above.
Remove clamping nut and backing flange.
Loosen and remove the three clamping screws.
Carefully remove the spring washer with the three balls,
the drive plate and the washer. Thoroughly clean all parts.
Replace defective parts. Lubricate spring disc ball traveler
with a little multi-purpose grease. Refit all parts in reverse
sequence, making sure that the drive plate and spring
washers are correctly aligned (grooves).
Hex socket head screws M3x6 are used for ten-
sioning the locking mechanism.
3.1.2 A
dditionAl hAndle
The additional handle must be screwed in at the left or
right, or in the gearbox head at the top.
3.2 g
rinding tools
Use only clean tools!
21
Publicidad
