Output Connections - WEG CFW500 Serie Manual Del Usuario

CALL NOW 800-985-6929

3.2.3.5 Output Connections

The characteristics of the cable used to connect the motor to the inverter, as well as its
interconnection and routing, are extremely important to avoid electromagnetic interference in
other equipment and not to affect the life cycle of windings and bearings of the controlled motors.
Keep motor cables away from other cables (signal cables, sensor cables, control cables, etc.),
according to
Connect a fourth cable between the motor ground and the inverter ground.
When using shielded cables to install the motor:
Follow the safety recommendations of IEC 60034-25.
„
Use the low impedance connection for high frequencies to connect the cable shield to the
„
grounding. Use parts supplied with the inverter.
The accessory "CFW500-KPCSx power and control cable shielding kit" can be mounted in the
„
lower part of the cabinet.
of the power supply and the motor cable shield to the accessory CFW500-KPCSA. Besides,
this accessory allows the connection of the control cable shield.
CALL NOW 800-985-6929
http://www.automatedpt.com
ATTENTION!
The inverter has an electronic motor overload protection that must be adjusted
„
according to the driven motor. When several motors are connected to the
same inverter, install individual overload relays for each motor
The motor overload protection available in the CFW500 is in accordance with
„
the UL508C standard. Note the following information:
1. Trip current equal to 1.2 times the motor rated current (P0401).
2. When parameters P0156, P0157 and P0158 (Overload current at 100 %,
50 % and 5 % of the rated speed, respectively) are manually set, the
maximum value to meet the condition 1 is 1.1 x P0401.
ATTENTION!
If a disconnect switch or a contactor is installed at the power supply between
the inverter and the motor, never operate it with the motor turning or with voltage
at the inverter output.
Item 3.2.6 Cable Separation Distance on page
Figure 3.3 on page 20
http://www.automatedpt.com
Email: charles@automatedpt.com
Installation and Connection
23.
shows a detailed example of the connection
Email: charles@automatedpt.com
CFW500 | 19