Storage
General Storage Instructions
•
Clean and maintain the device and ac-
cessories carefully before storage.
•
Keep the equipment in a dry and dust-
proof place out of reach of children.
•
Do not wrap the equipment in plastic
bags, as damp and mould may form.
•
Do not lie the device down on the pro-
tective cover.
•
Use transport protection (
when storing the blades.
•
The cable holder (
the device cable (
not remove the cable holder, even when
storing the device.
Storage During Working
Breaks
Non-observance of the storage
instructions can cause starting prob-
lems or permanent damage as a
result of fuel residues in the carbu-
rettor.
In case of working breaks of less
than 3 months:
1. Drain the fuel tank (7) in a well-ventilat-
ed place.
2. Start the engine and allow it to tick
over until the engine stops and the car-
burettor is free of fuel.
3. Allow the engine to cool (approx.
5 minutes).
In case of working breaks of more
than 3 months:
4. Loosen the spark plug (
spark plug wrench (
ing/Adjusting the Spark Plug").
31/32)
A
19) should hold
A
18) in position. Do
A
47) with a
J
23) (see "Chang-
A
5. Pour a teaspoon of pure 2-stroke oil into
the combustion chamber and pull the
starter cable slowly several times to dis-
tribute the oil inside the engine.
6. Reinsert the spark plug (
Transport
•
When it is being transported, the de-
vice must be switched off and the spark
plug connector (
transport the device when it is idling.
•
Carry the device with one hand on the
upper shaft tube and the other hand on
the lower shaft tube (
to avoid coming into contact with dan-
gerous parts when transporting it (e.g.
hot engine, cutting unit).
•
Use the blade guard (
transporting the blades.
•
Maintain a safe distance from other
people when transporting the device.
•
Do not transport the unit upside down,
as otherwise fuel might leak out.
•
Before transporting between two loca-
tions, empty the fuel tank with a petrol
suction pump.
Do not empty the fuel tank indoors,
near fire or when smoking. Gas va-
pours can cause explosions or fire.
Transporting in a vehicle: Secure
the device against tipping over and
damage. Ensure the device is securely
positioned.
Disposal /
Environmental Protection
Do not allow used oil and petrol residues
into the sewer system or drains.
Dispose of used oil and petrol residues
in an environmentally friendly way – take
them to a disposal point.
GB
MT
47).
J
2) removed. Do not
A
8+12) in order
A
31/32) when
A
51